China tac-coated graphite Manufacturers, Suppliers, Factory

The third generation of semiconductor materials AlN belongs to the direct bandgap semiconductor, its bandwidth of 6.2 eV, with high thermal conductivity, resistivity, breakdown field strength, as well as excellent chemical and thermal stability, is not only an important blue light, ultraviolet materials, or electronic devices and integrated circuits, important packaging, dielectric isolation and insulation materials, especially for high-temperature high-power devices. In addition, AlN and GaN have a good thermal match and chemical compatibility, AlN used as GaN epitaxial substrate, can significantly reduce the defect density in GaN devices, improve device performance.

Silicon Carbide generally uses the PVT method, with a temperature of more than 2000 degrees, a long processing cycle, and low output, so the cost of Silicon Carbide substrates is very high.

Gallium oxide (Ga2O3) as an "ultra-wide bandgap semiconductor" material has garnered sustained attention. Ultra-wide bandgap semiconductors fall under the category of "fourth-generation semiconductors," and in comparison to third-generation semiconductors such as silicon carbide (SiC) and gallium nitride (GaN), gallium oxide boasts a bandgap width of 4.9eV, surpassing silicon carbide's 3.2eV and gallium nitride's 3.39eV. A wider bandgap implies that electrons require more energy to transition from the valence band to the conduction band, endowing gallium oxide with characteristics like high voltage resistance, high-temperature tolerance, high power capability, and radiation resistance.

The processing of 4H-SiC substrate mainly includes the following steps:

In semiconductor fabrication, etching is one of the major steps, along with photolithography and thin-film deposition. It involves removing unwanted materials from the surface of a wafer using chemical or physical methods. This step is carried out after coating, photolithography, and developing. It is used to remove the exposed thin film material, leaving only the desired portion of the wafer, and then removing the excess photoresist. These steps are repeated numerous times to create complex integrated circuits.

Silicon material is a solid material with certain semiconductor electrical properties and physical stability, and provides substrate support for the subsequent integrated circuit manufacturing process. It is a key material for silicon-based integrated circuits. More than 95% of semiconductor devices and more than 90% of integrated circuits in the world are made on silicon wafers.